Related Manuals for Everdure FORCE
Summary of Contents for Everdure FORCE
- Page 1 Assembly, Operation & Maintenance Instructions FO R C E FUR NAC E Assembly, operation & maintenance instructions for Everdure by Heston Blumenthal FORCE™ & FURNACE™ gas barbeques and stands everdurebyheston.com...
-
Page 2: Table Of Contents
OPERATION AND MAINTENANCE INSTRUCTIONS FOR HBG2GUS, HBG2MUS, HBG2SUS, HBG2RUS, HBG3GUS, HBG3MUS, HBG3SUS and HBG3OUS GAS BARBEQUE RANGE Everdure by Heston Blumenthal outdoor gas barbeques. It is important that you retain these instructions, proof of purchase as well as other important documents about this product for of the appliance. -
Page 3: Important Safety Instructions
This appliance is not intended for and should never be used as a heater. 12. People with flammable clothing such as nylon etc. should keep well away from the Regular cleaning and covering with an Everdure by Heston Blumenthal barbeque 2. For your safety and enjoyment, read the instructions before using the appliance. -
Page 4: Appliance Details
Air is admitted at the underside of the combustion chamber (two 1.3in/35mm x column (W.C.). The Liquid Propane cylinder must be fitted with an Overfill Protection Barbeque FORCE FURNACE 0.8in/20mm gaps between the fat tray and the chamber through an oval hole 3in/75mm LEAK TESTING Device (OPD). -
Page 5: Outdoor Installation Guide
ANSI Z211.81. Make sure the burner valves are in the “OFF” For a list of accessories for this barbeque, go to the Everdure by Heston Blumenthal cool, place your left foot in front of the left rear leg to stabilise the barbeque and pull the barbeque sheltered from strong winds as this will drastically reduce cooking efficiency. -
Page 6: Cleaning & Storage
2. open lid during lighting is safe to touch. Painted and plastic surfaces can be cleaned using a mild household inspect and clean the burners. Use an Everdure Heston Blumenthal FORCE or FURNACE 3. make sure the gas control knob is in “OFF” position. -
Page 7: Troubleshooting
Remove grill/plate and visually check the electrode for a spark. Check that the cables to ignition point, or from the valve to the chassis have not broken or disconnected. Also check the alignment of the sparker. If there is no spark, contact service provider. INCLUDED PARTS FORCE AND FURNACE Injector is blocked Clean injector with a toothbrush. - Page 8 Assembly, Operation & Maintenance Instructions Assembly, Operation & Maintenance Instructions STEP 01 Angle the assembly slightly to the back and remove both M6x0.8in (20mm) screws, then do the STEP 05 same at the front, supporting the parts so they don’t drop. Keep all of the fasteners for later /Open the hood and fix the hood handle (15) using two M5x0.6in (15mm) screws (F), two / Turn the stand onto its legs and check that all of the legs are stable.
- Page 9 Assembly, Operation & Maintenance Instructions Assembly, Operation & Maintenance Instructions STEP 08 STEP 10 STEP 11 STEP 07 / To extend the left hand side servery, support the front of the barbeque and pull the /Place the grills onto the barbeque as shown in the diagrams. Each grill should have a /Take the match holder (09) and fix into place using a M6.12in (12mm) screw (K), nut M6 left hand servery forward (approximately 0.4in (1cm)) tensioning the spring.
-
Page 10: Maintenance
Assembly, Operation & Maintenance Instructions MAINTENANCE STEP 012 PROCEDURE FORCE GRILL: REMOVING THE BURNER TUBES STEP 03 /Slide the burners toward the rear of the grill & remove ignition cables from the burner /Inspect the burners for insect webs and nests or any other blockages, the burner tube &... - Page 11 Assembly, Operation & Maintenance Instructions Assembly, Operation & Maintenance Instructions CHECKING THE BURNERS FOR FLAME STABILITY: GAS SUPPLY BARBEQUE AND HOOD Visually check the burner flames for correct function when the unit’s operating by inspecting the burner flame / flames with the cooking plates & grills removed. A good LEAK TESTING GENERAL: Although gas connections on the grill are leak tested prior 1.
- Page 12 Assembly, Operation & Maintenance Instructions Assembly, Operation & Maintenance Instructions PARTS LIST: FORCE BARBEQUES Left Hand Servery Leg Cap RR Injector Bracket (HBG2) Leg Cap FR PART NAME Injector Housing Bottom Shelf Support L Hood HBG2 (Orange) Injector (HBG2) Castor...
- Page 13 Assembly, Operation & Maintenance Instructions Assembly, Operation & Maintenance Instructions PARTS LIST: FURNACE BARBEQUES Left Hand Servery Leg Cap RR Injector Bracket (HBG3) Leg Cap FR PART NAME Injector Housing Bottom Shelf Support L Hood HBG3 (Orange) Injector (HBG3) Castor Hood HBG3 (Mint) Injector Housing Nut Foot FL...
- Page 14 HBG2OUS HBG2GUS HBG2RUS HBG2MUS HBG2SUS FURNACE 3 B U R N E R IM Ref: FORCE&FURNACEUS 11/2016/30 G A S B A R B E Q U E FOR OUTDOOR USE ONLY HBG3SUS HBG3OUS HBG3MUS HBG3GUS eve rd u re byh e s to n .c o m...
Need help?
Do you have a question about the FORCE and is the answer not in the manual?
Questions and answers