Westinghouse QK0232 Owner's Manual page 7

Installation (continued)
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out in the counter to
test its fit. Ensure that the reveal is equal on all four sides
when viewed from above . Make adjustments to the cut-out if
necessary .
- When you are satisfied with the location of the sink (A), mark
the location of the edge of the counter cut-out on top of the
sink and all around the sink flange underneath the counter.
- Set the sink aside and proceed with the rest of the
installation .
A
DRILLING THE HOLES FOR THE
UNDERMOUNT CLIPS
CAUTION: Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- On the underside of the counter, mark the location of the ten
holes for the undermount clips (F) . These holes should be
equally spaced around the sink flange outline as shown below.
They should be set back from the sink flange outline by 5/8 in
(15 .8mm) .
- Using an electric drill with a 3/8 in . (10 mm) drill bit, drill each
hole so that it is 3/8 in . (10 mm) in diameter and 5/8 in . (15 .8
mm) deep . Use a drill bit depth stop to ensure you do not drill
through the counter top .
5/8 in
15.8 mm
Undermount Clip Hole locations
7
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Sink Flange Outline
(Underside of Counter)
CONGLOMKB .COM