Maximum Rinse Level; Suds Cooling; Low Water Pressure; Anti-Crease - Miele WWF 060 Operating And Installation Instructions

Maximum rinse level

The water level in the rinse can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent wash
results. The water consumption will be
increased.
The function is switched off in the de-
fault setting.

Suds cooling

Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Nor-
mal program with a temperature setting
of Hot+ or higher is selected.
Suds cooling should be activated:
– To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– Where the drainage pipes do not
comply with DIN 1986.
Suds cooling is switched off in the de-
fault setting.

Low water pressure

If the water pressure is below 14.5 psi
(100 kPa), the program will be can-
celed and the fault message
will appear.
See 
If the on-site water pressure cannot be
increased, activating this function will
prevent the program from being can-
celed.
Low water pressure is switched off in
the default setting.

Anti-Crease

The Anti-crease function helps prevent
creasing after the end of the program.
At the end of the program, the drum
continues to turn for up to 30 minutes.
The washing machine door can be un-
locked and then opened at any time by
touching the Start/Stop sensor button.
Anti-crease is switched on in the default
setting.
Settings
Drainage
81