Frequently Asked Questions; The Display Indicates The Following Messages Or Faults - Miele TWI 180 WP Operating Instructions Manual

With the help of the following guide minor faults in the performance of the
machine, some of which may result from incorrect operation, can be remedied
without contacting the Service Department. Time and money will be saved
because a service call will not be needed.
This guide may help you to find the reason for the fault, and how to correct it.
Some of the messages in the display are more than one line long. Touch the  or
 sensor button to read them in full.

The display indicates the following messages or faults

Message
000 lights up after
switching on.
End/Cooling down

Soft Steam

Open & close door

Clean the lint filter
and the plinth filter.
See  lights up
at the end of a
program.

Frequently Asked Questions

Possible cause and solution
Access via a PIN code has been activated.
 You can enter the code.
See "Settings – PIN Code".
The laundry will be cooled down at the end of the
program.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
This is to remind you that water is taken from the
condensed water container when the
program is being used. The condensed water
container must be filled with water to at least the –
min– marker.
 Fill the condensed water container.
To switch off the message:
 Confirm with OK.
This it to remind you to load the laundry when the
SoftSteam program is selected.
 Load the laundry in the drum.
There is a build-up of lint in the airways.
 Clean the lint filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
 Confirm with OK.
Soft Steam
57