Other; Factory Reset, Clearing All Memory; Maintenance - JVC UX-N5 Instructions Manual

Compact component system
Table of Contents

Advertisement

Other

Factory Reset, Clearing All Memory

1
Press the [A] button of this unit to turn off
the power.
2
While pressing down the [OPEN/CLOSEM]
button, press the [A] button.
"Clear All" will be displayed.
Caution
By this operation, all data inside of the memory (clock,
timer setting, TUNER preset, etc) is deleted, and
factory reset is complete.

Maintenance

Before transporting the unit
Remove iPod/iPhone/iPad, USB devices or eject a CD
from the unit, and shut off the power of this unit. Keep
iPod/iPhone/iPad or USB devices connected or a CD
being left inside the disc tray may cause malfunction.
Care of compact discs
To take out from the case
Remove the disc from its case by holding it at the
0
edge while pressing the centre hole lightly.
Do not touch the shiny surface of the disc, or bend
0
the disc.
Put the disc back in its case after use.
0
Be careful not to scratch the surface of the disc when
0
placing it back in its case.
Keep your discs away from direct sunlight, heat, and
0
excessive moisture.
Do not write on either side of the disc, particularly
0
the non-label side from which signals are read. Do
not mark this surface.
44
To place back to the case
Do not play discs of special shapes (heart, flower,
0
etc). It may cause malfunctions.
Do not wipe it with thinner or benzine.
0
If a CD is dusty, clean it with a soft, dry cloth and
0
remove dirt or fingerprints.
Straight out from the
centre, along the radius
Precautions on water drops
In any of the following cases, you may not be able to
play back a disc correctly due to water droplets on the
lens inside of the unit.
After the room has been heated.
0
After moving the unit from a cold room to a warm
0
room.
When the unit has been kept at a damp place.
0
In these cases, use the unit after turning on the power
and waiting for about 1 to 2 hours.
Cleaning the cabinet
Stains should be wiped off with a soft cloth. If the unit
0
is heavily stained, wipe it with a cloth soaked in
water-diluted neutral detergent and wrung well, then
wipe clean with a dry cloth.
Since the cabinet may deteriorate in quality,
0
become damaged or get its paint peeled off, do not
wipe it with thinner or benzine. Dot not apply any
volatile sbstances such as insecticides to it. Do not
allow any rubber or plastic to remain in contact for a
long time.
Consecutive scratches can
cause noise or mistracking.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents