Subscribe to Our Youtube Channel
Related Manuals for PYLE Audio PLR7N
Summary of Contents for PYLE Audio PLR7N
- Page 1 MOTORIZED 7 ” ” IN -DASH LCD COLOR MONITOR WITH AM/FM STEREO RADIO PLR7N MODEL: OWNER ’ ’ S MANUAL...
- Page 2 Any changes or modifications in construction of this device which is not expressly approved by the party responsible for compliance could void the user’ ’ s authority to operate the equipment.
- Page 3 WARNING The exclamation point within an equilateral triangle and “ “ WARNING” ” are intended to alert the user to the presence of important operating instructions. Failure to heed the instruction will result in severe injury or death. DO NOT WATCH VIDEO WHILE DRIVING Watching the video may distract the driver from looking ahead of the vehicle and cause an accident.
- Page 4 CAUTION The exclamation point within an equilateral triangle and “ “ CAUTION” ” are intended to alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a level, where you can still hear outside noises while driving .
-
Page 5: Fuse Replacement
CAUTION The exclamation point within an equilateral triangle and “ “ CAUTION” ” are intended to alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. Operation of some of the functions of this unit is very complex. Because of this, it was deemed necessary to place these functions into a special SETUP screen. - Page 6 MONITOR ⑩ ① ② ⑨ ⑤ ⑥ ③ ① ① POWER ON/OFF BUTTON ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ④ ④ SOUND MUTE BUTTON ⑤ ⑤ VOLUME UP/DOWN ADJUST BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑦ ⑦ OPEN/CLOSE BUTTON ⑧...
-
Page 7: Remote Controller
REMOTE CONTROLLER ① ⑫ ③ ② ⑨ ⑪ ① ① POWER ON/OFF BUTTON ⑥ ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ⑤ ④ ④ SOUND MUTE BUTTON ④ ⑤ ⑤ VOLUME UP/DOWN BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑩... -
Page 8: Remote Control Unit
REMOTE CONTROL UNIT Replacing battery Applicable battery : Use two “AAA” sized dry batteries. 1. Opening the battery cover. Push and slide the cover in the arrow direction, and the cover will be removed. 2. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-) polarities as shown in the diagram inside the unit. -
Page 9: Basic Operation
POWER ON / OFF 1. POWER ON 1) Press the POWER button to turn the power on. But the monitor will not open. 2) You can also turn the power on by pressing the OPEN/CLOSE button. The power will be on and the monitor will open. 2. -
Page 10: Closing The Monitor
CLOSING THE MONITOR 1. Hold left and right upper side of the monitor and set the left and right angle of the monitor parallel with the front of the unit as the picture. 2. Press OPEN/CLOSE button. The monitor will close. NOTE 1. -
Page 11: Adjusting The Slide Position
ADJUSTING THE SLIDE POSITION 1. Press the MENU button repeatedly on radio or AV mode until the USER SELECTOR menu is selected. 2. Press the SEARCH UP/DOWN button to select MOVE 3. Press the VOLUME ▶ button to select FORWARD. The monitor will slide one step (15mm) to the front. -
Page 12: Selecting Mode
SELECTING MODE Press the MODE button to select the desired mode. Each time you press the button, the mode changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD OR VCD CHANGER) -> AV4 (TV) NOTE 1. AV3 has only video input. 2. - Page 13 ADJUSTING THE TV/VIDEO PICTURE MODE (ASPECT) Each time you press A (ASPECT) button, the picture mode switches between Normal, Full, Zoom and Wide. NOTE You can also select the picture mode manually by pressing the function button on the unit as follows.
-
Page 14: Radio Control
Press the OPEN/CLOSE button to turn the power on and to open the monitor. The monitor shows following picture. NOTE 1. Each time you press the MENU button on RADIO MAIN MENU screen, the menu on the screen changes as follows. RADIO SUB ->... -
Page 15: Radio Sub Menu
AUTO MEMORY OF STATION 1. Tune in desired radio station you wish to store on the CH number. 2. Press the AS/ATM button for at least 2 seconds. The frequency on the display continues to change while the auto memory is in progress. The tuner will automatically seek and can store up to 30 stations in each band in order of frequency signal. -
Page 16: Radio Band
RADIO BAND 1. Press the SEARCH UP/DOWN button to select RADIO BAND. 2. When RADIO BAND is selected, press the VOLUME ◀ or ▶ button to select the band. Each time you press the VOLUME ◀ or ▶ button, the band switches as follows. FM1 ->... - Page 17 SETTING THE NAVIGATION 1. Connect a NAVIGATION system only to AV1 or AV2 Input terminals on the rear of the unit. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. 4. Press the SEARCH UP/DOWN button to select NAVIGATION. 5.
-
Page 18: Setting The Camera In
SETTING THE CAMERA IN 1. Connect a Back View Camera video output only to AV1,2 or 3 video Input terminals on the rear of the unit. * When the VCD changer is connected to AV3 Video input, The back view camera can be connected only to AV1 or AV2 video input. -
Page 19: Cd Changer Control
When a CD (VCD) changer is connected to this unit with 8 pin DIN cable, AV3 mode changes to CDC mode and CDC control menu is displayed on the screen. 1. Press the MODE button to select CD CHANGER (AV3) mode. Each time you press this button, the display changes as follows. -
Page 20: Track Number
TRACK NUMBER 1. Press the SEARCH UP/DOWN button to select TRACK NUMBER. 2. Each time you press the CH UP button, the next track number will be selected forward and the displayed track number increases by one. 3. Each time you press the CH DOWN button, the previous track number will be selected and the displayed track number decreases by one. - Page 21 DIRECT CD CHANGER CONTROL On the CD changer mode, you can directly control CD changer functions just by pressing the buttons on the remote controller for our monitor unit. STOP ■ button : to make the playing of the disc stop. PAUSE button : to stop the playing of the disc .
-
Page 22: Adjusting The Volume Of Each Channel
You can adjust the volume level of each channel of the radio or AV sources connected to this unit. ADJUSTING THE VOLUME OF EACH CHANNEL 1. Press the MENU button repeatedly on radio or AV mode until VOLUME MENU is selected The monitor shows following picture. - Page 23 1. Press the MENU button when the monitor shows following picture. The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item. FINE ADJUSTMENT FOR CENTER FREQUENCY AND TILT/SLIDE POSITION VOLUME MENU...
-
Page 24: Picture Menu
1. Press the MENU button when the monitor shows following picture. The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item. SCREEN CONTROL USER SELECTOR MENU USER SELECTOR... - Page 25 1. Press the SEARCH UP/DOWN button to select COLOR SYSTEM for the video source on PICTURE menu. 2. Press the VOLUME ◀ or ▶ button to select PAL or NTSC for the video source. NOTE To select the color system for the TV when the TV tuner box is connected to the AV4 input of this unit, 1.
- Page 26 To adjust audio level of AV sources on AV mode, 1. Press the VOLUME ◀ or ▶ button. The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the audio level of the selected item. NOTE 1.
-
Page 27: Warning Screen
WARNING SCREEN The monitor shows following warning picture when the parking brake is not set or when driving to prevent traffic accident that may be caused while watching the screen. The monitor shows the warning picture only and does not show any other pictures, but you can enjoy the sound only by adjusting the volume. - Page 28 AV INPUT FACE PLATE OF THE UNIT Front View NOTE 3.5 Ø AV input on the front face of the unit is same input with AV1 input on the rear of the unit. If the sources are connected both input terminals,the 3.5Ø...
-
Page 29: Installation
PRECAUTIONS Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. -
Page 30: Basic Connections
(Blue/White) (Blue) (Brown) (Red) (Yellow) (Black) (Orange) SPEAKER FRONT RIGHT SPEAKER REAR RIGHT SPEAKER REAR LEFT SPEAKER FRONT LEFT 1. Be sure that the PARKING SENSOR WIRE must be grounded or NOTE opened. If it is connected to ACC (B+). The unit can be damaged. 2. - Page 31 CONNECTING TO CD CHANGER AND TV TUNER BOX YELLOW WHITE...
-
Page 32: Specifications
AM SECTION USA BAND Frequency Range Frequency Step EUROPE BAND Frequency Range Frequency Step Intermediate Frequency Usable Sensitivity Image Rejection Ratio IF Rejection Ratio FM SECTION Frequency Range Frequency Step Manual tuning Seek tuning Intermediate Frequency Usable Sensitivity Image Rejection Ratio IF Rejection Ratio CD CHANGER Signal/Noise Ratio... - Page 33 Printed In Korea...
Need help?
Do you have a question about the PLR7N and is the answer not in the manual?
Questions and answers