Bosch GKS 65 Operating Instructions Manual page 20

1 609 929 H32.book Seite 7 Mittwoch, 20. April 2005 7:56 07
– Set the circular saw with the premounted
guide-rail adapter 31 and adjust the guide
rail 28 and set the cutting angle and cutting
depth.
– When setting the cutting depth, take into con-
sideration that the cutting depth is reduced by
the height of the guide rail.
– Align the circular saw with the guide-rail
adapter 31 in such a way that the teeth of the
saw blade lie against the edge of the rubber
lip.
– Make sure that the guide rail is not sawn into
(Fig. II and III).
II
31
0°-Cut 1 – 45°-Cut
– Tighten the winged screw for the parallel
guide 7 to ensure a firm connection between
the guide-rail adapter 31 and the circular saw.
– Remove the circular saw from the guide
rail 28.
– Place the guide rail on the workpiece in such a
way that the rubber lip lies exactly along the
cutting edge (marked line) and tighten using
screw clamps 26.
The guide rail 28 must not extend beyond
the face side of the work where the cut is to
be started.
– Position the saw, ensuring that the guide-rail
adapter 31 is seated firmly.
– Saw through the material, applying moderate
and steady feed.
Note: Two guide rails can be connected to one
with use of the connection piece 29 (acces-
sory). Clamping is carried out with the four
screws located in the connection piece.
20 • 1 609 929 H32 • 05.04
Maintenance and Cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean. Remove dust and chips by
blowing out with compressed air or with a brush.
Saw blades that are not coated can be protected
against corrosion with a thin coat of acid-free oil.
Before use, the oil must be removed again, oth-
III
erwise the wood will become soiled.
Resin and glue residue on the saw blade produce
poor cuts. Therefore, clean the saw blade imme-
31
diately after use.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized after-sales
service centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
English - 7
To be fitted
by qualified
professional only