Cisco cBR Hardware Installation Manual page 63

Installing the Supervisor in the Cisco cBR Chassis
1 Tethered I/O door
Step 2 Connect the mini type-B USB connector of the console cable to the console port on the Supervisor Card.
Figure 53: Console Port Connection on the Supervisor Card
1 Mini type-B USB connector
Step 3 Connect the type-A USB connector of the console cable to the Exar XR21V1410 UART with USB interface.
Step 4
Connect the Exar XR21V1410 UART to the appropriate serial port on the PC or terminal using a cable with type-A USB
connector on one end and DB-9 connector on the other end.
Step 5 Power up the PC or terminal.
Step 6 Configure the PC terminal emulation software or the terminal with the following settings:
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
Using the Console Port on the Supervisor Card
—
2 Console cable (with mini type-B USB connector
on one end, and a type-A USB connector on the
other end)
Cisco Converged Broadband Routers Hardware Installation Guide
63