Cisco cBR Hardware Installation Manual page 45

Installing the Supervisor in the Cisco cBR Chassis
Step 6
Press the SFP+ module into the slot firmly with your thumb until it is latched securely into the socket.
Step 7 Repeat Step 1, on page 43
What to Do Next
• Verify if the SFP+ module is seated and latched properly. Grasp the SFP+ module and try to remove it
•
Installing the Supervisor Card in the Cisco cBR Chassis
Perform this procedure to install the following cards:
• Supervisor Card
• Blank card for the Supervisor
Before You Begin
If you are adding a new Supervisor Card or upgrading the existing Supervisor Cards, ensure that the power
Warning
modules installed in the chassis are adequate to support the Supervisor Cards.
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
•
• Be aware of the weight and size of the equipment. Handle it with care.
Restrictions
• If you are using a single Supervisor, you must install the Supervisor Card in the slot corresponding to
Required Tools and Equipment
• ESD-preventive wrist strap
• Supervisor Card or blank card for the Supervisor
to Step 6, on page 45
without releasing the latch. If the SFP+ module cannot be removed, it is installed and seated properly.
If the SFP+ module can be removed, reinstall it.
Connect fiber-optic cable to the SFP+
connected to the chassis.
Install the Supervisor PIC (recommended).
the Supervisor PIC.
In the Cisco cBR-8 router,
Note
• Slot 4/1 for the Supervisor PIC corresponds to slot SUP0 for the Supervisor Card.
• Slot 5/1 for the Supervisor PIC corresponds to slot SUP1 for the Supervisor Card.
Installing the Supervisor Card in the Cisco cBR Chassis
for each SFP+ module.
port.
Cisco Converged Broadband Routers Hardware Installation Guide
45