Cisco cBR Hardware Installation Manual page 51

Installing the Supervisor in the Cisco cBR Chassis
• RJ-45 cable
• Switch
Step 1 Connect one end of the RJ-45 cable to the NME port on the Supervisor PIC.
Figure 39: NME Port Connection on the Supervisor PIC
Step 2 Connect the other end of the RJ-45 cable to a switch.
What to Do Next
Route the RJ-45 cable through the Supervisor PIC cable management bracket and chassis-mounted fiber/cable
routing
Using the Console Port on the Supervisor PIC
The console port provides local administrative access to the router and its command-line interface (CLI).
Before You Begin
•
•
Restrictions
• Each Supervisor PIC must have a console port connection when running a redundant configuration in
Required Tools and Equipment
• RJ-45 cable
• RJ-45-to-DB-9 adapter
guide.
Install the Supervisor PIC.
Install the Supervisor Card.
the chassis.
Using the Console Port on the Supervisor PIC
Cisco Converged Broadband Routers Hardware Installation Guide
51