Studiomaster MIXDOWN Owner's Manual page 7

Aux 5.
13 PAN control
when the channel is routed to L-R outputs. It can
also bias
numbered groups
position. Panning
numbered groups only, panning fully right
to even-numbered groups only.
14 CLIP indicator.
the signal approaches the maximum running
It monitors
and illuminates
LED also illuminates
is depressed,
While indicating SOLO, it ceases to act as a CLIP
indicator.
15 SOLO button.
allows the
monitor/headphone
channels which are in SOLO condition). The signal
level can be seen on the RIGHT output bargraph.
16 CH. ON
button
when the switch is depressed. In the OFF position'
signals
most
exceptions
and Aux 5 (as it is pre-EQ) •
17 L-R routing
the post-fader,
left/right
signal may
in recording studios or for routing of signals to
the left/right
applications.
18 ROUTING BUTTONS.
channel signals
outputs simultaneously.
recording or subgrouping signals, such as
during live
routing is achieved using the PAN control.
19 FADER. High
10dB gain.
MIXDOWN
allows a left/right
the channel's
by moving
fully left
This LED
all stages within the input
at 4dB prior to
whenever the
to indicate that SOLO is
A pre-fade
channel signal to be isolated on
system (along with
LED
and indicator.
from the channel
are SOLO operation,
button. When depressed, this
post-pan signal directly to
outputs, bypassing the subgroups.
be used for final multitrack
outputs
These allow
to any
For
sound reinforcement.
quality 100mm
stereo balance
output to odd/even
it from the
routes to
illuminates whenever
channel
clipping.
SOLO
in
monitor switch
any
LED
are muted.
CLIP indication
mixdown
in live performance
bussing of
combination of
use in multitrack
Exclusive
channel fader
zero
odd-
routes
level.
This
switch
use.
which
the
other
li9 hts
The
routes
the
The
the
group
drums,
with
o
FIG 1
5