Code CR2 User Manual page 91

Disconnect from the CR2 unit by scanning the code below.
9
Wait 20-30 seconds for the devices to disconnect.
Disconnect
10
Scan the following code below to enable device pairing:
Enable Pairing Mode
Scan to inquire and connect to the desired device.
11
Inquire and Connect
Note: It may take 20 - 30 seconds for the devices to connect. Observe
the connection status check-mark on the device ICON in the Bluetooth
Connection Manager upper screen and in the serial port connection
at the bottom of the screen.
CR2 User's Manual Draft_022803_AS - 84