Available Parameters At Enduser Level - Adisa ADI CD 70 Technical Manual Of Installation, Use And Maintenance

ADI CD boiler - Technical Manual

10.3 Available parameters at enduser level


When you are in the main display, press

Choose the required parameter by turning the setting knob
parameters depending on the required adjustments.
Time of day and date
Operator section
Time prog heating circuit 1
Time prog heating circuit 2
Time prog 3/heating circuit 3
Time program 4/DHW
Time program 5
Holidays heating circuit 1
Holidays heating circuit 2
Holidays heating circuit 3
Heating circuit 1
Heating circuit 2
Heating circuit 3
DHW
Boiler
Fault
Maintenance/special operation
Diagnostics heat generation
Diagnostics consumer

Press the button

If nothing changes after 8 minutes or any other button has been pressed, you will come back to the initial
display and changes won't be saved.
Level
to get out of the programming Enduser level.
to enter at "Enduser level".
Line nr.
1 Hours/minutes
2 Day/month
3 Year
20 Language
500-516 Preselection, Phases
520-536 Preselection, Phases
540-556 Preselection, Phases
560-576 Preselection, Phases
600-616 Preselection, Phases
641-648 Periods, Start-End
651-658 Periods, Start-End
661-668 Periods, Start-End
710 Comfort setpoint
712 Reduced setpoint
714 Frost Protection setpoint
720 Heating curve slope
730 Summer/winter heating limit
1010 Comfort setpoint
1012 Reduced setpoint
1014 Frost Protection setpoint
1020 Heating curve slope
1030 Summer/winter heating limit
1310 Comfort setpoint
1312 Reduced setpoint
1314 Frost Protection setpoint
1320 Heating curve slope
1330 Summer/winter heating limit
1610 Nominal setpoint
2214 Setpoint manual control
6705 SW diagnostic code
7130 Chimney sweep function
7131 Burner output
7140 Manual control
8338 Hours run counter burner
8527 Total yield solar energy
8530 Hours run solar yield
8701-8702 Outside temp min-max
and confirm with OK. Modify the
Function
24