Optional Installations - EcoSmart EL40 Installation, Operation And Maintanance Manual

ENGLISH
INSTALLATION

OPTIONAL INSTALLATIONS

Installing the wired Touch Control
1. Locate and remove the access door on the rear right side of the
fire unit.
2. Locate the Wired Touch Control directly inside the access panel. Pull
the touch control through the access panel and replace the access
door. Locate the touch control anywhere within cable length.
3. The wiring of the Wired Touch Control cannot be located near high
voltage wires (110V) as this may effect performance of the touch
control. Keep all high voltage power at least 12" (305mm) from the
touch control and touch control wiring. The touch control includes 12
feet of wiring. Do not add or remove or cut the wiring.
The unit is hardwired and has no main switch. (Caution: If servicing this
unit, turn off power at the main circuit breaker.) An optional tethered
wall control switch is included, refer to installation instructions to
relocate the tethered wall control switch to a wall location.
The included Wired Touch Control functions in the same manner as the
buttons on the tethered wall control switch.
www.ecosmartfire.com
Power
Heat
Backlight
Indicator Lights
When all indicator lights are off, touching any button will only show the
status. Once the indicator lights are on you can begin operation. Touch
the power button to turn the machine on. This will be indicated by 1
orange LED light. The Heat button can be pressed multiple times and
will turn on low, high and off in that order. The Backlight button turns on
high, medium, low and off in that order.
When the switch turns on, this orange
pilot lamp is always on. It shows the fire is
energized.
The status light above shows that the power
is on and the heater is on low.
The status light above shows that the power
is on and the heater is on high