Curtis G4TP2S10A3500 User Manual page 8

INSTALLATION INSTRUCTIONS
Connect the Brewer Wiring (cont.)
Brewers With A Cord Set Attached
WARNING: Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician. Do
not modify the power plug. Do not use an extension
cord. Do not use a power cord/plug that is damaged.
11 Connect the power cord to the appropriate type of
electrical outlet.
Power Up the Brewer
12 Turn on the water supply valve.
13 Make sure that the circuit breaker supplying power to
the unit is on.
14 Turn the toggle switch on the back of the brewer to the
15 Go to the PROGRAMMING GUIDE section and
program the brewer for the correct model and batch
number.
IMPORTANT:
higher elevations, reduce the operating
temperature by 2°F for each 1000 feet of
elevation. See PROGRAMMING GUIDE.
16
volume, the heating elements will turn on automatically.
Depending on the incoming water temperature and
requires 20 to 30 minutes to reach the factory set
"Ready to Brew" should be on the display.
17
hot water through the hot water faucet to help purge air
from the tubing inside the brewer.
18 Brew a cycle of at least 12 ounces, to purge any
remaining air from the tubing. See OPERATING
INSTRUCTIONS. During the initial brew cycle and
water tank.
G4 THERMOPRO, INSTALLATION INSTRUCTIONS
II9
Back of brewer
011917NC