Do you have a question about the 803/50402 and is the answer not in the manual?
Questions and answers
Lucy Ash
May 31, 2025
Do you have instructions for the John Lewis Bow slatted bed?
1 comments:
Mr. Anderson
May 31, 2025
The instructions for the John Lewis Bow slatted bed with part number 803/50402 are:
- Use the bed only on firm, level ground. - Ensure it is fully assembled as illustrated before use. - Do not use power tools during assembly to avoid overtightening and panel failure. - Check the parts list before assembly to ensure all components are present. - Tighten all screws and bolts but do not overtighten. - Regularly inspect and re-tighten bolts if needed. - Ensure the bed legs stay in contact with the ground at all times. - Do not stand on the bed. - Keep small parts away from children. - Disassemble the bed before moving to avoid injury or damage and retain all fittings.
Assembly time is 40 minutes and requires one person. Tools are not required.
Page 1
The fittings pack contains which should be CHILDREN Read this leaflet in full before commencing assembly. If you require any additional information or have any issues with this product please call the John Lewis Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com...
Page 2
Fittings and parts checklist Bedstead Parts Headboard x 1 Footboard x 1 Side Rails x 2 Wooden Slats x 28 Cross Bars x 2 Support Legs x 3 Centre Rail x 1 Fittings JCBC Bolt x 12 Washer x 8 (M6 x 25 mm) JCBC Bolt x 5 M6 JCN Nut x 6...
Page 3
Step by step assembly instructions Step One Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Washer (A) and JCBC M6 x 25 mm Bolt (B). Tighten using Allen Key (H) as shown in the diagram below. Repeat this for all 4 corners.
Page 4
Step Three Ensuring the holes along the Centre Rail (7) are facing upwards, attach to the underside of the Cross Bars (5) using M6 x 30 mm Bolt (C) and M6 Nut (D). Screw the Adjuster (E) fully into the bottom of the Supporting Legs (6).
If you require any additional information or have any issues with this product please call the John Lewis Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.com...
Need help?
Do you have a question about the 803/50402 and is the answer not in the manual?
Questions and answers
Do you have instructions for the John Lewis Bow slatted bed?
The instructions for the John Lewis Bow slatted bed with part number 803/50402 are:
- Use the bed only on firm, level ground.
- Ensure it is fully assembled as illustrated before use.
- Do not use power tools during assembly to avoid overtightening and panel failure.
- Check the parts list before assembly to ensure all components are present.
- Tighten all screws and bolts but do not overtighten.
- Regularly inspect and re-tighten bolts if needed.
- Ensure the bed legs stay in contact with the ground at all times.
- Do not stand on the bed.
- Keep small parts away from children.
- Disassemble the bed before moving to avoid injury or damage and retain all fittings.
Assembly time is 40 minutes and requires one person. Tools are not required.
This answer is automatically generated