Maximum Rinse Level; Suds Cooling; Low Water Pressure; Anti-Crease - Miele WCI 660 WCS Operating Instructions Manual

Maximum rinse level

The water level in the rinses can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent rinse
results. The water consumption will be
increased.
The maximum rinse level is deactivated
as standard.

Suds cooling

Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tons programme with a temperature of
70 °C or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
Suds cooling is deactivated as stand-
ard.

Low water pressure

If the water pressure is below 100 kPa
(1 bar), the programme will be can-
celled and a fault message will appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being can-
celled.
Low water pressure is deactivated as
standard.

Anti-crease

The Anti-crease function reduces
creasing after the end of the pro-
gramme.
At the end of the programme, the drum
continues to turn at intervals for up to
30 min. The washing machine door can
be unlocked at any time by touching the
Start/Stop sensor and then opened.
Anti-crease is activated as standard.
Settings
97