Hyundai Genesis Cupe 2016 Owner's Manual page 125

Features of your vehicle
Reprogramming a single
®
HomeLink button
To program a device to HomeLink
®
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the
®
HomeLink button. DO NOT release
the button.
2. The indicator light will begin to flash
after 20 seconds. Without releasing
®
the HomeLink button, proceed
with "Programming" step 2.
For questions or comments, contact
®
HomeLink at www.homelink.com or
1-800-355-3515.
4 42
Erasing HomeLink
Individual buttons cannot be erased.
®
However, to erase all three pro-
grammed buttons:
1. Press and hold the two outer
desired ®
HomeLink buttons until the indi-
cator light begins to flash after 10
seconds.
2. Release both buttons. Do not hold
for longer than 20 seconds.
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be pro-
grammed at any time following the
appropriate steps in the Programming
sections above.
® FCC ID: NZLTLMHL4
buttons
IC: 4112A-TLMHL4
This device complies with Part 15
of the FCC Rules.
Operation is subject to the following
two conditions:
1. This device may not cause harm-
ful interference, and
2. This device must accept any inter-
®
Wireless
ference received, including inter-
ference that may cause undesired
operation.
CAUTION
The transceiver has been tested
and complies with FCC and
Industry Canada rules. Changes
or modifications not expressly
approved by the party responsi-
ble for compliance could void
the user's authority to operate
the device.