Hyundai Genesis Cupe 2016 Owner's Manual page 107

Features of your vehicle
If the power window is not operated
correctly, the automatic power win-
dow system must be reset as follows:
1. Turn the ignition switch to the ON
position.
2. Open the window fully by manual
down(press the front portion of the
switch to the first detent position.).
3. Turn the ignition switch to the OFF
position and to the ON position
again within 2 seconds.
4. Press the front portion of the
switch 3 times within 5 seconds.
5. Close the window and continue
pulling up on the power window
switch for at least 1 second after
the window is completely closed.
4 24
Automatic reversal
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resist-
ance and will stop upward movement.
The window will then lower approxi-
mately 11.8 in. (30 cm) to allow the
object to be cleared.
If the window detects the resistance
while the power window switch is
pulled up continuously, the window will
stop upward movement then lower
approximately 1 in. (2.5 cm). And if the
power window switch is pulled up con-
tinuously again within 5 seconds after
the window is lowered by the automat-
ic window reversal feature, the auto-
matic window reversal will not operate.
✽ ✽ NOTICE
The automatic reverse feature for
the driver's and front passenger's
windows are only active when the
"auto up" feature is used by fully
pulling up the switch. The automat-
ic reverse feature will not operate if
the window is raised using the
halfway position on the power win-
dow switch.
OBK049095
WARNING
Always check for obstructions
before raising any window to
avoid injuries or vehicle damage.
If an object less than 0.16 in. (4
mm) in diameter is caught
between the window glass and
the upper window channel, the
automatic reverse window may
not detect the resistance and will
not stop and reverse direction.