Using The Web Management Interface - Nortel 2221 Product Manual

Telnet or open the console connection to the Access Point 2220/2221.
1
2
3
For a list of commands available from the CLI, refer to Run Time Console
Specifications (part number 215113-A).

Using the Web Management Interface

To initially manage the Access Point 2220/2221 using the web management
interface, you must configure the network settings of the computers on your
wireless LAN to use the same IP subnet as the Access Point 2220/2221. The
default network settings assuming there is no external DHCP server for this device
are:
Access Point IP Address: 192.168.168.10
Gateway IP Address: 192.168.168.254
Subnet Mask: 255.255.255.0
The IP address of the connected client PC from which system configuration is to
be performed should be 192.168.168.x (where x means 1–9, 11–253).
When you have connected to the Access Point 2220/2221, you will see the
following prompt:
Username:
Enter:
nortel
You will see the following prompt:
Password:
The default is no password. Press Enter.
The EXEC mode prompt appears:
Nortel Enterprise AP#
Using the Nortel Networks Wireless LAN Access Point 2220/2221
Chapter 3 System Configuration 25