Table of Contents
Advertisement
Step 13 Configure the
Manager. The
through SSH.
Cisco NAC Appliance supports using Strong Passwords for root user login. Passwords must
be at least 8 characters long and feature a combination of upper- and lower-case letters, digits,
and other characters. For example, the password
because it does not contain two characters from each category, but
password. For more details, see the
Appliance - Clean Access Manager Installation and Configuration Guide, Release
For security reasons, it is highly recommended that you change the password for
the root user.
** Please enter a valid password for root user as per the requirements below! **
Changing password for user root.
You can now choose the new password.
A valid password should be a mix of upper and lower case letters,
digits, and other characters. Minimum of 8 characters and maximum
of 16 characters with characters from all of these classes. Minimum
of 2 characters from each of the four character classes is mandatory.
An upper case letter that begins the password and a digit that ends
it do not count towards the number of character classes used.
Enter new password:
Re-type new password:
passwd: all authentication tokens updated successfully.
Step 14 Next type the password for the
Please enter an appropriately secure password for the web console admin user.
New password for web console admin:
Confirm new password for web console admin:
Step 15 After the configuration is complete, press Enter to reboot the CAM. After rebooting, the CAM
will be accessible from the web console.
Configuration is complete.
Changes require a REBOOT of Clean Access Manager.
Enter the following command to reboot the CAM after configuration is complete:
# reboot
The CAM initial configuration is now complete.
Step 16 Test the installation:
a. Ping the eth0 interface address from a command line. If working properly, the interface should
respond to the ping.
36
user password for the installed Linux operating system of the Clean Access
root
user account is used to access the system over a serial connection or
root
admin
10-9=One
"Administering the
CAM" chapter of the
user for the CAM direct access web console.
does not satisfy the requirements
is a valid
1o-9=OnE
Cisco NAC
4.5(1).
Advertisement
Table of Contents
