Stand By; Dispensing Programmable Doses; Continuous Dispensing - La San Marco SM 92 INSTANT Original Instructions Manual

5.2 Stand by

Active dose key LED illuminated with high intensity (the meaning of the active key will become more clear
.
below). The other key illuminated with low intensity light

5.3 Dispensing programmable doses

Once the single or double dose key is pressed, the CPU will store this key in its memory as the only active
key for the next serving for models with a micro.
models without a micro
For models without a micro, the ground coffee will be served using the touch keypad.
Pressing a dispensing key (single or double), grinding will start and the display will show the countdown of
the selected dose; once dispensing is completed, the display will show a value of 00.0 for 2 seconds. If the
continuous dose is pressed (symbol ∞) the grinder-dispenser will work in start/stop mode (there is a safety
stop after 3 minutes).
models with a micro
When preselecting the desired dose (single or double) in standby, the display will show the programmed time
for the dose; then if the micro is activated, grinding will start and the countdown will start on the display;
once dispensing is completed, the display will show a value of 00.0 for 2 seconds.
The dispensing of the ground coffee will only start when the micro 13 is activated by the filter cup.
After this time has passed, the display will again show the dose time related to the key illuminated with high
intensity (that is, the one active for subsequent dispensing).
Using the keypad, it is possible to by-pass the consent of the micro and provide full control to the touch
control panel.
If providing power to the grinder using the main switch, there will be 3-4 seconds to press the key to the
upper right (key +) to access a menu where it will be possible, using the + key, to change the operating mode:
micro YES (M s) or micro NO (M n).
If this key ∞ (∞ the continuous symbol) is pressed for 5 seconds during this phase, the display will show "i
s" (infinite yes) or "i n" (infinite no). To switch from "i s" to "i n" and vice versa, simply press the + key.
Repressing the continuous key for 5 seconds, the display will again show the option micro Yes micro NO.
The key to the upper left (- key) is used to exit this mode unless it was already exited due to a time out
(30 seconds).

5.4 continuous dispensing

The continuous dispensing key (∞) starts the grinding without having to activate the micro.
For safety reasons, there will be a time delay of 1 second between touching the continuous key and starting
with the dispensing; this prevents involuntary starts. To stop the dispensing, simply touch the same key (∞).
During continuous dispensing, the display will show inF.
21