VeriFone Omni 5 series Installation Manual page 24

Hide thumbs Also See for Omni 5 series:
Table of Contents

Advertisement

T
S
ERMINAL
ETUP
Smart Battery
NOTE
Smart Battery
Installation
Smart Battery
Removal
Smart Battery
Charging
NOTE
24
O
5
I
MNI
XXX
NSTALLATION
Refer to
Spare Smart Battery Pack
terminal on the Omni 5xxx terminal.
The smart battery pack must be installed and holding a minimum of a 1% charge
to operate the Omni 5xxx terminal.
The smart battery installs in a slot on the back of the terminal, as shown in
15. The locking tab clicks when the battery is in place. The slot is keyed, so that
there is only one way to insert the battery.
Figure 15
Install the Smart Battery
To remove the smart battery, press the locking tab at the top of the battery and pull
the smart battery from its slot.
On initial use, the smart battery must be fully charged and fully discharged
through normal operation. After unpacking your Omni 5xxx terminal, install the
battery and connect the power pack to the unit for 24 hours. Disconnect the power
pack and allow your Omni 5xxx terminal to remain on until the smart battery
completely discharges. Reconnect the power pack to the unit and allow the smart
battery to recharge a maximum of 24 hours.
It is also recommended that the smart battery receive a periodic full discharge. To
ensure a full discharge, use the unit until the battery is fully drained.
To determine the charge state of the battery, push the "test button" icon (shown in
Figure
16) on the bottom of the battery. The bar LED status indicators on the
battery each indicate 25% of the charge state. When the battery charge state
reaches 10%, the
LED
battery charge state displays at the bottom of the first copyright screen when the
terminal is turned on.
Conserve battery power by turning the Omni 5xxx terminal off when not in use. If
the terminal is not to be used for several days, remove the battery from the
terminal as it continues to discharge even when the terminal is turned off.
G
UIDE
for smart battery instructions for the Omni 5xxx
(Figure
16) blinks, indicating a low-charge state. The
Figure

Advertisement

Table of Contents
loading

Table of Contents