Table of Contents
Advertisement
PARTS (see FIG. 1)
A
Mist outlet
B
Lid
C Water tank
D Mist chamber
E
Filter
F
Water tank cap
G Base
H LCD display/control panel buttons
I
Night light
J
Room temperature indicator
K
Room humidity indicator
L
Set humidity indicator
M Water tank empty
N Timer setting
O Mist level display
P
Warm mist button
Q Auto setting button
R Mist level button
S
Set humidity button
T
Night light on/off button
U Timer button
V
On/off button
ASSEMBLY INSTRUCTIONS
1. Be sure your humidifier is switched off and
disconnected from the wall outlet.
2. Install the Mist chamber (D) into the Base (G).
3. IMPORTANT: To eliminate the emission of
minerals from the water, it is recommended that
the Water Filter is always used.
4. Place the water tank (C) into the body.
IMPORTANT: Make sure the water tank as well
as the inside of the base are clean before using
the appliance and after storing for a long time.
5. Ensure the humidifier is level. If the humidifier is
not level always turn the power off before
handling it.
OPERATING INSTRUCTIONS
Filling the Water Tank
NOTE: Always switch off and unplug your humidi-
fier before filling the water tank. The water you put
into the water tank should be clean and not be over
40°C (cold boiled water or demineralised water are
recommended).
1. Remove the lid and lift the water tank out of the
base.
2. Unscrew the filter/water tank cap (E and F).
3. Fill the tank with clean water to the MAX mark
then screw the filter/water tank cap back tightly
onto the tank.
4. Put the water tank back into the base.
5. Fit the Lid (B) and Mist outlet (A).
SWITCHING THE UNIT ON AND OFF
1. Plug the unit into the mains supply socket.
2. Press the On/Off button (V). The LCD display
(H) will light up white and the on/off button and
Auto button will light up blue.
3. By default, your humidifier will start in Auto
mode. Note that it will take up to 5 minutes
before auto mode will function normally and your
humidifier may produce mist during this time
even though the room humidity is higher than
55%. When the room humidity falls below 53%
your humidifier will operate normally.
NOTES: Your humidifier has a memory and will re-
member the previous settings after it has been turned
off. If the unit has been unplugged however, any
previous settings will be lost and the unit will default
to Auto mode when switched on again.
HUMIDIFIER SETTINGS
Your humidifier has a built-in room humidity indicator
(K) ideal for precise and continuous humidity level
monitoring. If your humidifier is in Auto mode, press
the Auto button to switch it into manual mode. Once
in manual mode, the Set Humidity button (S) will light
up. Press the Set Humidity button until the desired
humidity level is shown by the Set humidity indicator
(L). The humidity can be selected from 40% to 70%
in 5% steps or Continuous. To turn your humidifier to
continuous mode, select Cn.
Your humidifier will operate until the set humidity level
is reached. Your humidifier will resume operation
when the humidity level in the room falls below the
set level.
NOTE: When the preset humidity is reached and your
humidifier stops producing mist, the fan will still keep
running to help read the room humidity precisely.
MIST SETTINGS
Your humidifier has three mist levels selected by
pressing the Mist level button (R). The levels are
shown by the bars in the Mist level display (O).
4
Hide quick links:
Advertisement
Table of Contents
