Panasonic CS-SA18CKP Service Manual page 31

8.5. In case of embedded Piping
For the embedded piping
Follow the same procedure for left rear and left piping.
8.5.1. Replace the drain hose
8.5.2. Bend the embedded piping
• • • • Use a spring bender or equivalent to bend the piping so that
the piping is not crushed.
8.5.3. Install the indoor unit.
8.5.4. Cut and flaring the embedded
piping
• • • • When determining the dimensions of the piping, slide the
unit all the way to the left on the installation plate.
• • • • Refer to the section "cut and flaring the piping" in the
directions for the outdoor unit. (see P.27)
8.5.5. Pull the connecting cable into the
indoor unit.
8.5.6. Connecting the piping
• • • • Refer to the section "connecting the piping" in the directions
for the indoor unit.
(Connecting the piping to the outdoor unit and checking the
gas leakage.)
8.5.7. Connecting the cable to the indoor
unit
• • • • The cable can be connected without removing the front
grille.
8.5.8. Install the indoor unit fixly.
[REFERENCE Fig.B, Fig.C]
31
CS-SA18CKP / CU-SA18CKP5
Fig.B
Fig.C