Advertisement
TIMETRAX™ SYNC RF WIRELESS DIGITAL CLOCK
Installation Instructions (cont.)
BATTERY MODELS (LCD)
Install metal security bracket onto a standard electrical box, or if not using electrical box, hold security
bracket flush against wall, level & mark four screw holes close to corner tabs. Drill holes as marked and
secure bracket to wall using provided screws and wall anchors.
Install two lithium C size batteries (part #42224 sold separately) into compartment on back of clock. Clock
will initially display
receiving a radio signal (typically 1-2 minutes).
Push clock onto security bracket aligning four tabs on bracket with four matching slots on back of terminal.
Slide clock downward until locking tab clicks into place. When properly mounted, clock cannot be slid up
and off bracket without using included wall bracket release key to disengage locking tab (see page 2 for
diagram).
I2255
Page 3 of 5
888.479.7264
pyramidtimesystem.com
.. Clock will synchronize to the RF Wireless Transmitter immediately upon
Advertisement
