Advertisement
TIMETRAX™ SYNC RF WIRELESS ANALOG CLOCK
Installation Instructions (cont.)
WIRED MODELS
WIRING SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN AND IN COMPLIANCE WITH ELECTRICAL CODE.
Install metal security bracket onto a standard electrical box.
Make electrical connections. This should only be performed by a licensed electrician.
Push clock onto security bracket aligning four tabs on bracket with four matching slots on back of terminal.
Slide clock downward until locking tab clicks into place. When properly mounted, clock cannot be slid up
and off bracket without using included wall bracket release key to disengage locking tab.
Upon power up, clock will initially hone itself to 12:00. Clock will synchronize to the RF Wireless
Transmitter immediately upon receiving a radio signal (typically 1-2 minutes).
BATTERY OPERATED MODELS
Install one lithium C size battery (part #42224 sold separately) into compartment on back of clock. Clock
will initially hone itself to 12:00. Clock will synchronize to the RF Wireless Transmitter immediately upon
receiving a radio signal (typically 1-2 minutes).
Hang clock on security bracket (see steps 1&3 above).
I2254
Page 2 of 4
888.479.7264
pyramidtimesystem.com
Advertisement
