Drain Pump - AGA marvel 30iMT Installation, Operation And Maintenance Instructions

Figure 5
⁄ " O.D. drain
5
8
tubing and hose
clamp
Ice Machine
8 ⁄ "
3
8
(21.3cm) 6 ⁄ "
3
4
(17.1cm)
4 ⁄ "
1
16
(10.3cm)
21 ⁄ "
1
2
(54.9cm)
Figure 7

DRAIN PUMP

The Marvel Drain Pump is designed to remove drain water
from ice machines installed in areas without direct drainage
access. The sealed reservoir pump collects the melted ice
water and pumps it to a maximum lift of eight (8) feet (2.44
meters) through
This pump has been evaluated for use with water only.
1 ⁄ " Drain pipe
1
Reasonable care and safe methods should be practiced.
2
Do NOT work with energized electrical equipment in a wet
area. Read and follow the installation instructions listed in
this manual.
Access
panel
Risk of electric shock - This pump is supplied with a
Figure 6
grounding conductor and grounding-type attachment plug.
To reduce the risk of electric shock, be certain that it is con-
nected only to properly grounded, grounding-type recep-
tacle.
Access
panel
Maintenance
The following items require review on a regular basis.
1. Check that the vent line is open, free of kinks/sharp
2. Check that the discharge tubing is free of foreign mate-
⁄ " (1.4cm)
9
16
18"
(45.7cm)
2 ⁄ " (6.0cm)
3
8
14 ⁄ "
3
4
(37.5cm)
Drain
Access
6
⁄ " I.D. vinyl tubing to a drain.
3
8
NOTE
bends, so that air fl ows freely from the pump reservoir.
rial (algae, etc.) and kinks/bends. Confi rm that the
check valve is operational by observing that the water
fl ow is evident in one (1) direction only - out of the
pump. Remove and clean as required.