Table of Contents
Advertisement
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result
Refer to Figure 1 for the following warning.
Warning:
with this appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE:
LS-(18, 24, 30)RS
(Figure 1)
support.
pan.
pan.
7. Compare the completed log installation with the appropriate
photo from pages 10 through 12. Review previous steps to
make any necessary adjustments.
8. Log placement is completed.
Attention: Do not use Figure 1 to order replacement logs. Refer to
Page 13 Parts List and Parts View to order logs for your appropriate
model number.
Apply loose material (glowing embers) per appropriate Installation
adversely affect performance of the heater. WARNING: All previously
applied loose material must be removed prior to reapplication.
Replacement Loose Material (glowing embers) Part Number
Note: A single layer of embers is to be used when applying Platinum
Bright Embers (alone or in combination with production embers)
to the burner.
LS-18RS
LS-24RS
LS-30RS
Platinum Bright Embers
28189-0-1210
SASSAFRAS LOG PLACEMENT
15999
15970
15970
PE-20-1
Log Placement
LS-(18, 24, 30)RS Logs
The following WARNING applies when log set is installed onto an
unvented gas burner assembly.
propane) gas. Field conversion is not permitted.
Figure 1
Page 9
Advertisement
Table of Contents
