Husqvarna Rider 213C Operator's Manual page 17

2. Remove the 3 screws (B) and lift off the right fender.
B
To remove the left fender
• Remove the 3 screws and lift off the left fender.
To examine the steering wires
The tension of the steering wires can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note: Do not park the product on a grass slope when
you do a check of the parking brake.
2. Press the parking brake pedal down (1).
374 - 001 - 29.09.2017
B
A
B
3. Press and hold the lock button (2) and release the
parking brake pedal while the button is pressed.
1
4. If the product starts to move, let an approved service
agent adjust the parking brake.
5. Press the parking brake pedal again to release the
parking brake.
To replace the fuel filter
1. Open the engine cover to access the fuel filter.
2. Move the hose clips away from the fuel filter with a
pair of flat pliers.
3. Pull off the fuel filter from the hose ends.
4. Press the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
5. Push the hose clips against the fuel filter.
To clean and change the air filter
1. Open the engine cover.
2
17