Advertisement
Quick Links
Advertisement
Related Manuals for Cansec Canlan M200
Summary of Contents for Cansec Canlan M200
- Page 1 Canlan M200 QUICK START GUIDE April 2014 Cutting edge simplicity...
- Page 2 NOTE: The cross-over network cable provided may be used instead of the USB cable. Refer to the Canlan M200 Installation Manual for important connection information. 4. Verify the COM port number used by the Canlan M200 by going to: Control Panel > System >Hardware > Device Manager->Port. Example “USB Serial Port (COM4)”.
- Page 3 6. Select Connect via Serial Port and choose the appropriate COM port from the drop-down menu. CanLan M200 Page 3 of 6 Quick Start Guide April 2014 • Rev. 1.3...
- Page 4 7. Power on the Canlan M200 using the AC-DC adaptor provided. If the Canlan M200 is already powered on, use a pin to press and release the reset button in the reset pin hole. Device Reset Button 8. Press OK within 20 seconds. You should see the message Unit Online along with all default configuration parameters.
- Page 5 3. Wait for the Cfg/Err LED to come on then click the Connect button to retry the connection. 4. For more troubleshooting tips, see the Canlan M200 Installation Manual. CanLan M200 Page 5 of 6 Quick Start Guide April 2014 •...
- Page 6 7. Optionally, click Backup to back up the configuration to a binary file for future restoration. The file will be saved in the same folder as the Canlan configuration software. CanLan M200 Page 6 of 6 Quick Start Guide April 2014 • Rev. 1.3...