Advertisement
1. Phone Numbers and Emergency Phone Numbers
Note: Up to 90 digits can be stored in each of the 5 phone number and 5 emergency phone number positions.
Phone Numbers
The number programmed in the first location under "Phone Numbers" is the telephone or extension number that is
dialed when the hard wired button or center button on the BTR-3 wireless remote is momentarily pressed.
Additional numbers (if programmed) will be dialed when there is no answer and the Dial Next No. on Ring No Answer
feature is enabled. The 40TP-IP speaker phone will cycle through the programmed phone numbers until answered.
Emergency Phone Numbers
The number programmed in the first location under "Emergency Phone Numbers" is the telephone or extension number
that is dialed when the hard wired button or center button on the BTR-3 wireless remote is pressed and held for 3 or
more seconds. Additional numbers (if programmed) will be dialed when there is no answer and the Dial Next No. on
Ring No Answer feature is enabled. The 40TP-IP speaker phone will cycle through the programmed emergency phone
numbers until answered.
2. Security Code
The security code allows the user/installer to program the 40TB-IP phone. The factory set security code is 845464. It
is recommended that the factory set security code be changed.
Note: The security code must be 6 digits and cannot include a Q or a #.
3. Access Code
The Access Code is used for remotely operating the relay (Doorstrike, Mag-Lock, etc) by calling into the unit. This code
provides basic security and only allows operation of the relays and not the ability to change any of the programming
parameters. Once entered, any of the "Remote Access Operation Commands" can be used. The code can be 1 to 6
digits in length and cannot contain a "Q" or "#". Simply call the 40TB-IP phone (set to auto-answer/auto-answer secure),
the unit will automatically answer the line and output one beep. You then enter the programmed 1 to 6 digit access
code, 2 beeps should be heard. You can now enter any "Remote Access Operation Commands" (see page 19).
4. Call Priority over Paging Groups
Incoming and outgoing SIP call audio streams can be programmed to have priority over any of the 10 paging groups.
Simply check the Incoming or Outgoing calls box then use the drop down menu to select which group/s you want SIP
calls to have priority over.
5. Paging Sources
Up to 10 multicast paging groups can be programmed into each 40TB-IP speaker. Each multicast group is defined by
a multicast address and port number. Each multicast group is assigned a priority, allowing simultaneously arriving pages
to be serviced based on importance. A timeout check box can be selected for each paging group. See Page Length
Time Out under Speaker Settings to adjust the timeout from 1 to 255 seconds. Only one timeout time can be
programmed for all groups.
Assigning Priority
The 40TB-IP will prioritize simultaneous audio streams according to their priority in the Paging Sources list. Group 0
will have the highest priority while group 9 will have the lowest priority. Group 9 is useful for a low priority stream such
as background music. Group 0 is useful for high priority streams such as emergency messages.
The multicast paging groups can also be used for up to ten different paging zones for receiving audio streams. A paging
zone can consist of one or many 40TB-IP multicast speakers. There is no limit to how many speakers can be in a given
paging zone. Each multicast group is defined by a multicast address and port number. Each multicast group is assigned
a priority, allowing simultaneously arriving pages to be serviced based on importance.
Programming Features
11
Advertisement
