Kenwood TK-80 Service Manual page 54

Item
14. Power 1) M CH: 23
frequency
response
15. Spurious 1) M CH: 24
adjustment
16. Suppression 1) M CH: 25
adjustment
17. SWR 1) M CH: 26
protection
adjustment
18. SWR 3.0 1) Power ON while holding the
(for AT)
adjustment
19. CAR point 1) Menu No.: 27 (LSB)
adjustment
20. ROM data 1) Turn the [DIAL] to select Menu No. 39.
writing
21. Display 1) Menu No.: 36
check
22. Transmit 1) Check for following frequency Power meter Rear
output
power
Current
consumption
Spurious
(during
HI power)
Downloaded from www.Manualslib.com
Condition
equipment
Power meter Rear
Transmit
Power meter
Transmit Spectrum
analyzer
Coupler
Set USB/LSB using [MODE]
key.
Transmit
150Ω
150Ω dummy load connect. dummy load
Transmit Pass-
through type
power meter
[SCAN] and [DATA] keys.
(Service adjustment mode)
Menu No.: 24
150Ω dummy load connect.
Transmit
Power meter
Menu No.: 28 (USB) AG
AG1: 300Hz/3mV Oscilloscope
AG2: 2700Hz/3mV Coupler
Transmit
M CH: 28 (1.8MHz, AM) Spectrum panel
M CH: 31 (7MHz, CW) analyzer
M CH: 34 (26MHz, USB) AG
SSB: AG 1kHz, 50mV input
AM: Unmodulated Linear
Transmit detector
f. counter
manuals search engine
ADJUSTMENT
Measurement
Test-
Terminal
Unit Unit
ANT Final
panel
TX-RX VR3
Front
panel
Display (READY) → Press [MODE] or [DATA] → Write → Finish (GOOD)
ANT
Front MIC
panel
Adjustment
Parts Method
VR3 Power maximum 95W or more
Spurious minimum –50dB or more
(Near ± 1.6MHz)
VR7 CAR level minimum –50dB or more
VR8 Repeat USB and
LSB alternately,
adjust CAR level to
minimum.
VR14 40W ± 4.0W
[MODE] 1 push
or
[DATA]
While observing the
oscilloscope wave-
forms, adjust so the
waveforms cross.
At LSB or USB,
adjust while pressing
[MODE] or [DATA]
key.
Check LCD all segments light.
Transmit output No display
power (RF meter
lights up all) HI
Press [MENU] key MID
one time, set to the
menu number "01" LOW
by pressing [DATA]
or [MODE] key.
Change to HI, MID, *( ): AM mode
LOW by turning the
[DIAL].
No display: 20.5A or less
HI: 15A or less
MID: 12A or less
LOW: 9A or less
Higher harmonic
Other: –40dB or less
TK-80
Specifications/Remarks
OK
NG
: 90~110W (20~30W)
: 45~55W (10~15W)
: 22~28W (5~8W)
: 13~17W (2~5W)
: –50dB or less
53