Boiler's Operating Modes - BaltGaz NEVALUX 7224 User Manual

The symbols on display show the boiler's operation mode. Around the display there are 6 boiler control
buttons. The designation of the control buttons and of the symbols shown on display are represented in the
tables 2 and 3 respectively.
Control buttons designation
Symbol
K1
K2
K3
K4
K5
K6
Displayed symbols designation
Symbol Is always glowing
Antifreeze function operating symbol
(see. p. 3.3.1, page9)
Presence of flame on the burner
Standby mode
Boiler in the DHW standby mode
Boiler in the heating standby mode
Error code, reset request
Error code, technical service
required
Parameter number displayed
Remote control is connected
3.2. Boiler operation modes
The boiler can function in the following modes:
DHW mode (see p. 3.2.2);
combined mode (see p.3.2.3, page9);
heating mode (see p.3.2.4, page9);
When the boiler is connected to the electricity network, it automatically sets up to the mode in which it was
before being switched off from the network. Change of boiler's operating mode is effectuated by pressing the
K5 button on the boiler's control panel (see p.3.1, page7). Below the sequence of the boiler's operating modes
change is represented.
User's manual
Parameter programming (see p.13.3.1, page26)
3.2.1);
Table 2
Function
DHW temperature increase
DHW temperature reduction
Heating temperature increase
Heating temperature reduction
Choosing the boiler's operation mode, switching the
boiler on/off (see p.3.2)
Reset of the boiler's electronic board blocks
(RESET)
Table 3
Flickering
Boiler operating in the DHW mode
Boiler operating in the heating mode
Parameter value displayed
Remote control connection error
User's manual