Advertisement
ADC-16 USER GUIDE
The README.DOC File
To learn of last-minute changes, be sure to read the ASCII file R E A D M E D O C . This is an ASCII text
file that is readable with any text editor (word processor) or with the DOS TYPE command.
The FILES.DOC File
To learn the contents of your Distribution Software, refer to the ASCII file FILESDOC
.
This file lists
and describes each of the files in the Distribution Software. This is an ASCII text file that is readable
with any text editor (word processor) or with the DOS TYPE command. FILES.DOC lists and briefly
describes the contents of the Distribution Software.
2.5 THE
CONFIGURATION PROGRAM
Overview
NOTE:
Before you can run the Configuration Program, you must install the Distribution
Software (Section 2.4).
Your ADC-16 Distribution Software includes the Configuration Program ADC16CFG.EXE
,
whose
purpose is to assist you in setting u p Board parameters and saving them to a new or existing
configuration file. The default configuration file in your Distribution Software is ADCI6.CFG
;
however, the Configuration Program allows you to save a set of parameters to any configuration file
you specify.
A configuration file is a necessary reference for Call Driver programs (Chapters 6 and 7) and for the
Pop Up Control Panel. The file contains information such as the number of ADC-16s in use, Base
Address, Range, Interrupt Level, and the number of STA-EX8s linked to each Board. If you bypass the
configuration program, the Call Driver refers to the ADC16.CFG default file.
Factory Defaults
Factory settings for the ADC16.CFG file are as follows:
BoardNumber
0
Board Name
ADC16
Base Address
&H300
Range
3.2768
Number Type
SignMagnitude
Interrupt Level
7
Installed STA-EX8s
0
Running the Configuration Program
To start the configuration program, log to its directory, and type
ADCl6CFG
follow the on-screen instructions.
f i
1
ename . Then
2 - 4
Advertisement
