Advertisement
CHAPTER 2
INSPECTION, CONFIGURATION, &
INSTALLATION
2.1 INSPECTION
After removing the wrapped Board (ADC-16) from its outer shipping carton, proceed as follows:
1.
Before unwrapping the Board, place one hand firmly on a metal portion of the computer chassis to
discharge static electricity from yourself and the Board (the computer must be turned Off but
grounded).
2.
Carefully remove the Board from its anti-static wrapping material.
3. Inspect the Board for signs of damage. If any damage is apparent, return the Board to the factory.
4.
Check the remaining contents of your package against the packing list to be sure your order is
5. When you are satisfied with preliminary inspection, you are ready to configure the Board. Refer
complete. Report any missing items to the factory immediately.
to the next section for configuration options.
2.2 CONFIGURATION
Switch &
Jumper Settings
Figure 2-1. Location of Base Address switch and Input Range jumper.
2 - 1
Advertisement
