Common Accessory Settings; Security Settings; About Security Settings; Device And Sim Card Security - Nokia E52 User Manual

Automatic time update
•
time zone information automatically (network service).

Common accessory settings

Select Menu Ctrl. panel
>
Enhancement.
With most accessories, you can do the following:
To define which profile is activated when you attach an
accessory to your device, select the accessory and
profile.
To set the device to answer phone calls automatically after
5 seconds when an accessory is attached, select
Automatic answer
Beep once or Silent
answering is disabled.
To illuminate the device while it is attached to an
accessory, select Lights
Turn to silence calls or alarms
When you activate the sensors in your device, you can
control certain functions by turning the device.
Select Menu Ctrl. panel
>
Sensor settings.
Select from the following:
Sensors — Set the display to rotate automatically
•
according to the device's orientation.
Turning control
•
calls or snooze alarms when you turn the device face
94
— Update the time, date, and
Settings and General
>
> On. If the ringing type is set to
in the selected profile, automatic
> On.
Settings and General
>
— Set the device to silence incoming
2009-11-09 15:1:46
down. To enable this option, the Sensors option needs
to be activated.

Security settings

About security settings

>
Select Menu
>
Security.
Avoid using codes that are similar to emergency numbers
Default
to prevent accidental dialling of the emergency number.
Codes are shown as asterisks. When you change a code,
enter the current code, then the new code twice.

Device and SIM card security

To change the PIN code, select
PIN code. The new code must be 4 to 8 digits long. The
PIN code protects your SIM card against unauthorised use
and is provided with the SIM card. After three consecutive
incorrect PIN code entries, the code is blocked, and you
need to use the PUK code to unblock it before you can use
the SIM card again.
To set the keypad to lock automatically after a defined
period, select
period.
>
To set a time-out after which the device is automatically
locked and can be used only if the correct lock code is
entered, select
period. Enter a number for the time-out in minutes, or
select None to set off the autolock period. When the device
is locked, you can still answer incoming calls, and calls may
still be possible to the official emergency number
programmed into your device.
Ctrl. panel Settings
>
Phone and SIM card
Phone and SIM card Keypad autolock
>
Phone and SIM card
>
and General
>
>
Phone autolock