Power Supply - Wetif PMG102 User Manual

Power Supply

The computer can be powered using either the built in battery or the AC
Power Adapter plugged into any grounded AC power outlet.
Using the Battery
The primary source of power for the computer is a Lithium-Ion battery pack.
The battery pack will first need to be installed on the underside of the
computer. After following the battery installation instructions below, plug the
AC adapter into any electrical outlet and the computer will begin recharging
immediately. In the future, you should not have to access the battery pack
unless you wish to replace it with a fresh one.
Note:
1. The Battery LED lights green when
charging and will turn off when the
battery is fully charged.
2. When charging the first time, it is
recommended that the battery be
allowed to charge for no less than eight
hours.
3. It will take a longer time to complete the charging process, if the user is
using the computer at the same time.
To install and remove the battery
pack:
1. Power down the computer using the
Power Switch.
Installing the Battery:
2. Correctly align the battery
and the notches in the
battery bay. Firmly push
the battery toward the
computer until it clicks
CHAPTER 1 - Getting Started
7