Table of Contents
Advertisement
1.
QUICK START
This short introduction chapter assumes that you have the Recognoil detector drivers and
Recognoil Advanced / Professional SW installed on your TabletPC / PC. Otherwise, please
skip this chapter and proceed to page 7.
1) Connect the USB cable to the device. Please
use microUSB adapter if necessary.
2) Run the software using a desktop icon / Start
menu icon / Program list called „Recognoil
V2.2.1".
3) After a successful initialization, hold approx.
2 seconds the device trigger to activate quick
LIVE mode with which you can scan the
surface while moving the device.
4) Or you can click the trigger shortly to
activate the PHOTO mode. This mode
requires you to hold the device on one place
3 to 5 seconds after touching the trigger
again. After that a double beep is played,
marking the scanning complete.
5) Please note that the detected surface must
be disposed of any dust particles. Please use
dry compressed air, preferably pressurized
cans for electronics cleaning.
6) The most important value is the mean
detector output value, where a smaller value
shows cleaner surface, while bigger numbers
mean bigger oil contaminations. The values
does not have any units, it serves for
comparative purposes.
7) The displayed surface is approx. 12x18 mm.
You can adjust the contrast (limit) by moving
the slider control.
8) The data can be immediately exported as a
BMP / JPEG / GIF using the second menu
icon.
9)
Please find more info further in the user's
manual.
Please always mind the safety
precautions.
Recognoil – User's Manual
Software version 2.2.1_2015-02-21
3
-
-
Advertisement
Table of Contents
