List of Error Codes for Micro800 controllers
Error Code
Description
0xF8A0
The TOW parameters are invalid.
0xF8A1
The DOY parameters are invalid.
0xF8A2
The HSC parameters are invalid.
0xFFzz
A user-created fault from Connected
Components Workbench has occurred.
(zz indicates the
last byte of the
program number.
Only program
numbers up to
0xFF can be
displayed. For
program numbers
01x00 to 0xFFFF,
only the last byte
is displayed.)
Rockwell Automation Publication 2080-UM001B-EN-E - November 2011
Recommended Action
Perform the following:
• Correct the program to ensure that there are no invalid parameters.
• Build and download the program using Connected Components Workbench.
• Put the Micro800 controller on Run mode.
Perform the following:
• Correct the program to ensure that there are no invalid parameters.
• Build and download the program using Connected Components Workbench.
• Put the Micro800 controller on Run mode.
Perform the following:
• Correct the program to ensure that there are no invalid parameters.
• Build and download the program using Connected Components Workbench.
• Put the Micro800 controller on Run mode.
Contact your local Rockwell Automation technical support representative if the error
persists.
Troubleshooting
Appendix D
51