Keithley PDISO-8 User Manual page 22

3-4
Install the DriverLINX software and board as follows:
1. Place the DriverLINX PIO Series CD-ROM in your drive and wait a
few seconds. On most systems, setup starts automatically. If not, run
the setup.exe file, found in the root directory of the CD-ROM.
A DriverLINX Browser Introduction screen appears. Thereafter, the
DriverLINX CD Navigator screen appears automatically after waiting
a few seconds or after clicking Next.
On the DriverLINX CD Navigator and other DriverLINX Browser
Note:
screens, place the cursor over a menu item to see an explanation. A star
next to a menu item means that it was selected previously.
Before continuing with this installation, Keithley suggests clicking Read
Me First on the DriverLINX CD Navigator and reviewing the brief
information that appears.
2. On the DriverLINX CD Navigator screen, click Install DriverLINX.
An Install These DriverLINX Components screen appears.
3. Click Install Drivers, and then follow the series of on-screen
instructions. When done, the Install These DriverLINX Components
screen reappears.
4. If you do not plan to develop custom application software for your
PDISO-8 board, then skip to step 5. If you do plan to develop custom
application software, you must install DriverLINX interfaces before
writing the software. Install them now by clicking Install Interfaces
and following the series of on-screen instructions. When done, the
Install These DriverLINX Components screen reappears.
5. Click Install Documentation and follow the series of on-screen
instructions. This step installs the manuals. When done, the Install
These DriverLINX Components screen reappears.
6. If Acrobat Reader is not already installed on your system, install it
now. You need Acrobat Reader to read the manuals, a section of
which you must access in step 9. Click on Install Acrobat and follow
the series of on-screen instructions. When done, the Install These
DriverLINX Components screen reappears.
Installation