Accessories - Keithley PDISO-8 User Manual

Accessories

Warning
The following accessories are available for use with PDISO-8 boards at
voltages up to 30V RMS, 42.4V peak, or 60VDC:
STA-U — screw terminal panel. This accessory connects to the main
I/O connector of a PDISO-8 through a C1800 cable to connect all I/O
lines to labeled screw terminals.
STC-37 — screw terminal connector panel. This accessory connects
directly the main I/O connector of a PDISO-8 to provide
general-purpose, screw-terminal connections in a compact form
factor.
STP-37/FC — screw terminal panel with a female DB-37 connector.
This accessory connects to the main I/O connector of a PDISO-8
through a C-1800/M cable. The printed-circuit area of this accessory
is covered to provide extra protection against personal or tool contact
with signals.
C1800 — cable. The C1800 is an 18-inch ribbon cable terminated at
each end with a 37-pin, D-type connector.
C-1800/M — cable. The C-1800/M is an 18-inch ribbon cable
terminated at one end with a connector to fit the main I/O connector
of a board and terminated at the other end with a connector to fit the
I/O connector of an STP-37/FC accessory.
Refer to Section 4 for information on connecting these accessories to
PDISO-8 boards.
Do not use the STA-U, STP-37/FC, C1800, and C-1800/M accessories at
voltages above 30V RMS, 42.4V peak, or 60VDC. These accessories are
rated for 30V RMS, 42.4V peak, or 60VDC maximum. Use at higher
voltages may result in shock hazard.
1-3