Table of Contents
Advertisement
The KE-USBMX20 features a status LED on the side for user
feedback. When this light is Red, the unit has power but has not
been initialized by the system. Once initialized and scanning, the
LED will be Blue. When a key is detected as active, the LED will
light Green momentarily.
The KE-USBMX20.EXE Program
The KE-USBMX20 unit is shipped with a CD ROM containing the
KE-USBMX20.EXE utility program which is used for configuring
the unit. Configuration parameters include the defining of the
pins used as Rows and Columns, and the keystroke or keystrokes
generated by the activation of a key within the matrix.
Getting Started
To begin using the KE-USBMX20, follow the steps listed below.
1. Attach the KE-USBMX20 to the computer as described
on page 2 under the section "Computer Connections".
2. Insert the CD and save the contents to its own folder
on the hard drive. The CD may now be removed and
stored in a safe location for future use.
3. Open the folder that was created in step 2 and start
the configuration program by selecting the program
file KE-USBMX20.EXE.
*Note:
The programs must be copied to and run from its own
folder on the PC's hard drive. The CD itself should be reserved
for back up purposes only.
Status Feedback LED
Status LED
4
Advertisement
Table of Contents
