Table of Contents
Advertisement
To get the desired keystrokes for the keypad with the FN key
pressed, each cell has been programmed as shown below.
The keystrokes defined include macros to get the upper case
characters for the "A", "B", and "C" keys.
Now that the configuration has been created, be sure to save it
to disk and then Write it into the KE-USBMX20.
The following page shows the two matrix configurations based
on the state of the FN key.
Only one FN key should be used per configuration and the "Single
Key at a Time" checkbox must not be checked when using the
FN key.
18
Advertisement
Table of Contents
