Table of Contents
Advertisement
Open: Recall a previously saved configuration file by either
clicking on "Open" with the mouse or by pressing Ctrl+O on the
keyboard. Locate and select the name of the configuration file
on the PC that is to be opened.
Save: Once a configuration setup has been created on the
program screen, it is recommended that it be saved on the PC's
hard disk. Click on "Save" with the mouse or press Ctrl+S on the
keyboard, then choose a location to save the file.
Read from KE-USBMX20:
This option will read the
current configuration in the KE-USBMX20 and display it on the
screen. Click on "Read from KE-USBMX20" with the mouse or
press Ctrl+R on the keyboard to perform this operation. **
Write to KE-USBMX20: This option will write the current
configuration displayed on the screen to the KE-USBMX20.
The KE-USBMX20 can be programmed and re-programmed
as many times as necessary. Click on "Write to KE-USBMX20"
with the mouse or press Ctrl+W on the keyboard to perform this
operation. After the KE-USBMX20 has been loaded with the new
configuration, it will scan according to this new setup. **
** - Note that if multiple KE-USBMX20 units are detected, a
selection window will be displayed asking the user to select the
unit by it's serial number. The 8 digit serial number is located
on the side label of the KE-USBMX20.
Exit: This option exits and closes the KE-USBMX20.EXE
program.
*Note:
Make sure that the KE-USBMX20 is connected to the PC
before performing either the "Read to KE-USBMX20" or "Write to
KE-USBMX20" operations. If the KE-USBMX20 is not present, a
"The KE-USBMX20 was not Found" error will be displayed on the
computer screen.
8
Advertisement
Table of Contents
