Advertisement
8
Bulletin 6153 and 6154 Industrial Computers with Integrated CRT
Installation Instructions
Publication 6153-2.0
Environmental Considerations
For proper cooling, the computer requires a minimum free air space
of 7.6 cm. (3 in.) behind, 5.1 cm. (2 in.) above and below, and 2.5
cm. (1 in.) on the sides of the chassis. The computer is equipped with
fans to help ensure proper cooling.
Strong magnetic fields near the front of the computer outside the
enclosure could potentially distort the image over time. This type of
image distortion generally disappears after degaussing occurs. The
computer is designed to automatically degauss each time you cycle
AC power, or when you press the degauss button.
Note: The internal degauss will not prevent color impurities caused
by local magnetic fields. Make certain the Industrial Computer's
enclosure is free of residual magnetism.
Panel Mounting, Bulletin 6153
The panel on which the Industrial Computer is to be mounted should
be at least 14 gauge steel to insure a NEMA 4 seal and proper
support for the unit. The mounting hardware provided will
accommodate this minimum thickness panel and panels up to 6.35
mm (.25 in.) thick.
To install the Bulletin 6153 Industrial Computer:
1. Confirm that the shipping carton contains a package of 16 10-32
bolts with their washers and lock nuts. You will need 14 sets
(4-slot) or 16 sets (8/12-slot) for installation.
2. Refer to the physical dimension drawing for your unit and
confirm that there is adequate space behind the panel where the
unit is to be situated. Remember to allow extra space for air
circulation.
Bulletin 6153 with 4 slots, Figure 1 on Page 4.
Bulletin 6153 with 8/12 slots, Figure 2 on Page 5.
3. Refer to the panel cutout drawing for your unit for dimensions of
the panel cutout and location of mounting holes. Cut and drill the
panel.
Bulletin 6153 with 4 slots, Figure 5 on Page 10.
Bulletin 6153 with 8/12 slots, Figure 6 on Page 11.
Tip: it will be easier to install the computer if you support it with
a shelf or other support adjusted to the appropriate height.
4. Carefully remove the computer from its packaging. Avoid
damaging the panel gasket.
Advertisement
