Advertisement
Adjusting the Settings
TIME
EVENING
TIMER
1
8 HRS
5 SECS
12 MINS
Sets the time that lights will remain on after the detection zone is vacated.
Adjustable from approximately 5 seconds to 12 minutes. The factory setting
is 12 minutes.
PHOTOCELL
EVENING
TIMER
1
8 HRS
5 SECS
12 MINS
For night-only operation, turn the knob completely counterclockwise to (to
the MOON symbol). For 24-hour operation turn the knob all the way clock-
wise to the MOON/SUN symbol. Adjust counterclockwise to have the sensor
come on later at dusk, clockwise to have it come on earlier. The Factory
Setting is Night-only (MOON). If you set Evening Timer while set to 24 hour
operation Evening Timer will begin immediately after flipping switch.
SENSITIVITY
EVENING
TIMER
1
8 HRS
5 SECS
12 MINS
Increases or decreases the resposiveness and range of the
sensor (adjustable from 30% to 100%). The Factory Setting is 100%.
STEALTH-IN-1114
TIME
SENS
TIME
SENS
TIME
SENS
–
11
EVENING TIMER
–
+
1
The STL360 provides an alternative to normal motion-activated lighting. The
EVENING TIMER can keep lights on continuously - without motion - for 1 to
8 hours after dusk. This is great for evening activities requiring continuous
light. During vacations the EVENING TIMER provides a "lived-in" look by
simulating an occupant turning lights on at dusk, and then off at bedtime.
To activate the EVENING TIMER, flip the wall switch controlling the sensor
three times slowly (off-on-off-on-off-on) within 3 seconds. If you activate
the EVENING TIMER during daytime, the middle LED should start blinking,
–
+
indicating that the EVENING TIMER will start when dusk is detected.
Choose the length of time you want continuous lighting. For example, if you
set the EVENING TIMER to "8", the sensor will keep lights ON continuosly for 8
hours after dusk. Once 8 hours have passed, the sensor will revert to motion
activated mode. At dawn, the photocell will detect light and prevent lights
from turning on during the daytime. The Evening Timer Mode will continue
until you de-activate it.
If you do not want to use the
EVENING TIMER, do NOT flip the
switch 3 times, as described above.
To de-activate the EVENING TIMER,
switch the sensor OFF for at least
10seconds, then ON again. Sensor
will be in Automatic Mode. (After
+
completing the 30 sec warm-up period)
You can affix this label (right),
provided, to your indoor light
switch plate for easy referenc
EVENING
TIME
TIMER
8 HRS
5 SECS
12 MINS
e.
12
SENS
–
+
RAB
STEALTH360
To Keep Lights On:
Switch off-on-off-on
within 2 seconds. Resets
to Auto Mode at dawn.
To Set
Evening Timer:
To keep lights on for
1-8 hours after dusk, set
the Evening Timer knob
on the sensor, then flip
this switch off-on-off-on
within 3 seconds.
To Resume
Auto Mode:
Switch off for 10
seconds, then back on.
Advertisement
