Motorola AC1001C Manual page 8

1. Plug the telephone line cord into the socket marked
2. Plug the power adaptor into the socket marked
other end into the mains power wall socket. Switch on the mains power.
Installing and charging the conferencing unit
1. Remove the battery cover from the back of the conferencing unit and plug in the
rechargeable Ni-MH battery pack supplied.
2. Clip the battery cover back into place.
3. If you are charging the batteries for the first time, place the conferencing unit on the
base to charge for at least 16 hours continuously.
4. When the conferencing unit is fully charged,
display. Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery pack (1500mAh Ni-MH
rechargeable battery pack) supplied with your AC1001C.
BATTERY LOW WARNING
If icon is displayed on the screen, you must charge the conferencing unit before use
it again.
When charging,
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 7 hours talk time or up to 72
hours standby time on a single charge.
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
To keep your batteries in the best condition, leave the conferencing unit off the base for a
few hours at a time.
Running the batteries right down at least once a week will help them last as long as
possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out,
giving the conferencing unit less talk / standby time. Eventually they will need to be
replaced.
After charging your conferencing unit for the first time, subsequent charging time is about
6–8 hours a day. Batteries and conferencing unit may become warm during charging.
This is normal.
1
All talk and standby times are approximate and depend on features selected and usage
pattern.
8
icon will scroll on the display.
1
on the rear of the base.
on the rear of the base and plug the
icon will appear steady on the
Getting started