1. Manuals
  2. Brands
  3. Lectrosonics Manuals
  4. Transmitter
  5. WM
  6. Quick start manual

Lectrosonics WM Quick Start Manual

Watertight transmitter
Hide thumbs Also See for WM:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
Q
uick
S
tart
G
uide
Watertight Transmitter
WM
Updated for firmware v2.6
Digital Hybrid Wireless
U.S. Patent 7,225,135
Fill in for your records:
Serial Number:
Purchase Date:
®
This guide is intended to assist with
initial setup and operation of your
Lectrosonics product.
For a complete instruction manual,
visit and download at:
www.lectrosonics.com/US
13 November 2017

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lectrosonics WM

Summary of Contents for Lectrosonics WM

  • Page 1 U.S. Patent 7,225,135 Fill in for your records: This guide is intended to assist with initial setup and operation of your Serial Number: Lectrosonics product. For a complete instruction manual, visit and download at: www.lectrosonics.com/US Purchase Date: 13 November 2017...

  • Page 2: Controls And Functions

    When the transmitter is in SLEEP mode, the LED blinks green every few seconds. Audio Input Jack This is a threaded locking connector that accepts the Lectrosonics watertight WP con- nector. Battery Compartments and Thumb Screws The large knurled thumbscrews retain the batteries and maintain solid battery contact.

  • Page 3: Audio Button

    The FREQ button displays the selected operating frequency and also toggles the LCD between displaying the actual operating frequency in MHz and a two-digit hexadecimal number that corresponds to the equivalent Lectrosonics Frequency Switch Setting. This button is also used with the AUDIO button to enter standby mode and to power the transmitter on or off.

  • Page 4: Attaching And Removing The Microphone

    The recess in the opening retains the O-ring when the plug is tightened. The Lectrosonics M152WP lavaliere microphone is supplied with the WP plug already installed. Other microphones can also be terminated...

  • Page 5: Operating Instructions

    Loc reminder that the controls are locked. Once the transmitter is locked, it cannot be unlocked or powered off using the buttons. The only ways to unlock a locked transmitter are to remove the batteries or unlock it via the RM remote control. www.lectrosonics.com...
  • Page 6 This menu item allows frequencies to be selected in either 25 kHz or 100 kHz incre- ments. If the desired frequency ends in .025, .050 or .075 MHz, the 25 kHz step size must be selected. • Stp 100 Frequency steps in 100kHz increments • Stp 25 Frequency steps in 25 kHz increments LECTROSONICS, INC.

  • Page 7: Remote Control

    When the audio mute function is enabled and the unit is turned on and transmitting, only the audio level (input gain) can be adjusted by holding the AUDIO button in for a few seconds. www.lectrosonics.com...
  • Page 8 If the unit was set up in “standby” mode, it will be necessary to turn the transmitter off, then power it up again in normal operation so the RF output will be on. Then the other components in the sound or recording system can be adjusted. LECTROSONICS, INC.
  • Page 9 “standby” or when the transmitter is powered up in the normal operating mode. Hex Code The hexadecimal numbering system is unique to Lectrosonics where two alphanumeric characters correspond to the left and right switch settings on earlier analog transmitters that had mechanical rotary switches to adjust frequency.
  • Page 10 (like the Vaseline petroleum provided with the WM) that is on the O-ring seals. It is also possible to use the mug warmer to dry out the doors without removing them from the case as shown below.
  • Page 11 Replacement battery caps Early WM transmitters had standard battery caps. Later design included compartments inside the caps containing moisture absorbing desiccant beads. A kit model WM- DESIKIT is available that includes two replacement battery caps, O-rings, lanyards, a center thumbscrew and allen wrench.

  • Page 12: Limited One Year Warranty

    This warranty does not apply to used or demonstrator equipment. Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor. If Lectrosonics, Inc. cannot correct the defect in your equipment, it will be replaced at no charge with a similar new item.

Table of Contents