Toshiba AW-G9930S/G1130S Service Manual page 25

Parts
(2) Water intake 1) Remove the detergent case.
valve,
Water feed 2) Remove 2 back cover mounting screws at
case assy
3) Remove the back cover by inserting a
4) Disconnect 4 connectors of the intake valve.
5) Intake valve and water feed case are
6) Take out the intake valve and the valve
Note 1 : When replacing the intake valve, always
Note 2 : After mounting the water feed case, try
x Before stating washing, open the faucet and check that the water supply hose joint is
WATER LEAKAGE
(3) Lid switch
1) Remove the rear lid (6 screws).
2) Remove 2 lead wire clamps from the
3) Remove 4 top and back cover mounting
4) Remove the top cover by lifting at rear side
Procedure (
rear. (Photo. 5)
screwdriver (-) from the lower end of the
bottom.
structured together. Remove it by releasing
2 catches at rear side of the water feed case
and then by lifting it. (Photo. 6 )
mounting base from the water feed case
(3 screws). When reassembling, do not
forget to mount the packing and the spacer
(each 2 pieces). (Fig. 1)
use new packing and spacer supplied
with the intake valve.
to make a test operation and make sure
no water leakage exists before mounting
the back cover.
CAUTION
not loose and no water leaks.
The loose screw or hose joint may cause water leakage resulting in an unexpected
damage.
cabinet,
and remove wire harness from the cord
clamper (1 Screw). (Photo. 7)
screws (each 2 screws).
slightly and sliding forward.
: Notes)
– 24 –
Illustrations
(Photo. 5)
(Photo. 6)
Screws (x3)
Water
intake valve
Holder
Water feed case
(Fig. 1)
(Photo. 7)